Depending on the kind of damage, you can repair your marble countertop in a number of ways. Some stains are generally easy to repair, while others demand more of your time and efforts.
Below, we talk about six methods to fix your marble countertop damaged in different manners.
1. Waxing
Routine waxing will rebuild the shine to marble. Waxing will additionally form a defensive layer to the surface of the marble to keep further damage from water and scratches.
2. Varnishing
You can use polyurethane varnish to coat the surface of the marble countertop. Just like waxing, spreading polyurethane will form a guarding layer for your marble countertop’s surface. Even varnish also reinstates the shine to the marble.
3. Epoxy Sealant
For minor cracks, an epoxy sealant can be used. You will find this substance at almost every home improvement store. Before applying the sealant, wipe the countertop surface efficiently and let the surface dry. Apply the sealant to the breaks and use a neat moist cloth to clear away any excess epoxy. Let the sealant dry and then carefully polish to a blazing sheen.
4. Tin Oxide
Tin dioxide can be used to fix scratches and stains on the surface of the marble. This substance is usually available at building supply retailer and monument stores. It is also called grade polishing powder. Use a piece of felt fabric to apply the powder on the marble countertop. Delicately rub it into the marble’s surface till the point that the scratch or stain is cleared away.
5. Epoxy Adhesive
For cracked or chipped areas on the marble, cautiously take out the chip or broken piece. Properly clean the space with acetone and a clean cloth. Spread a thin layer of epoxy and then reapply the chipped or damaged piece with care. Clear away any leftover epoxy. Let it dry and then wax the spot or varnish using polyurethane.
If you think this is a lot of work for you, you can visit http://www.re-vive.co.uk that offers a great range of services including crack and chip repair also.
6. Poultice Stain Removal
If your marble countertop was damaged by calcium water stains, get rid of wax or other debris from the range of the stain.
Make a poultice of diatomaceous earth and 50-70 percent peroxide. Mix it until there forms a creamy consistency like thick whip cream or peanut spread.
Moist the stain space with distilled water. Spread the poultice mixture over the stain at a density of roughly ¼ inch. Wrap the poultice with plastic cover and totally seal the whole area. Jab a few little holes in the surface of the wrap to let the air in. Give the poultice at least 24 hours to dry. It should be completely dry. The poultice will then pull the stain totally out of the marble.
Once the poultice has dried, take off the plastic cover and remove it with a putty knife, being cautious not to scratch the marble. If necessary, repeat the procedure until the stain is completely gone.
